brujasdeaskani

How do you test the throttle position sensor on a Jeep Grand Cherokee?

Using a multimeter, you can test the function of the TPS by probing the signal wire and manually manipulating the throttle. The signal wire should send around one volt with the throttle closed, and close to five when it's fully open. via

What is a TPS on a Jeep Cherokee?

Jeep Cherokee Throttle Position Sensor (TPS) via

Where is the throttle position sensor 1996 Jeep Cherokee? (video)

https://www.youtube.com/watch?v=z74vI_Ac89Y

How do you adjust the TPS on a Jeep Cherokee?

Start the engine and while watching your meter, turn the TPS clockwise until the idle drops to normal and then rotate it back counterclockwise to your desired output voltage. via

Where is the throttle position sensor located on a 2004 Jeep Grand Cherokee?

On the Jeep Grand Cherokee, the TPS is located on top of the engine on the driver's side of the intake manifold. It is held in place by two Torx screws. via

Where is the TPS on 2000 Jeep Cherokee? (video)

https://www.youtube.com/watch?v=KnJkVFPfkJw

How do you reset the computer on a 2000 Jeep Grand Cherokee?

Disconnect the battery by removing the positive battery cable.

Ground the positive cable to the negative cable for 30 seconds to erase the electric charge in the capacitors.

Reconnect the positive cable to the battery.

Turn the key to on but do not start.

Turn the headlights on.

via

How do you reset the PCM on a Jeep Grand Cherokee?

Step 1 – Prepare to reset the ECU.

Step 2 – Disconnect the battery.

Step 3 – Ground positive cable to the negative cable.

Step 4 – Reconnect the battery.

Step 5 – Turn the headlights on and then off.

Step 6 – Turn key to the "OFF" position.

via

How do I reset my Jeep Cherokee? (video)

https://www.youtube.com/watch?v=hw4ohl6Q8SI

What does the lightning bolt on dash mean?

The lightning bolt on the dash means that there is a problem with the electronic throttle control system in your vehicle. via