How do you reset the anti theft system on a 2002 Chevy Malibu?

Turn the key clockwise to lock the door. Turn the key counterclockwise to unlock the door again. This will shut the alarm off and reset the system. via

Where is the starter relay on a 2002 Chevy Malibu? (video)

https://www.youtube.com/watch?v=TC_k9yre88U

How do you reset the security system on a 2005 Chevy Malibu?

Registered. Try to reset your pass lock system. Try to start the car, when it wont start, just leave it in the Run/On position as if it had started. Wait 10 minutes and the security light will be solid. via

Where is the fuse box located on a 2001 Chevy Malibu?

Fuse box location

It is located on the passenger's side of the instrument panel, behind the cover. via

How do I reset my 2000 Chevy Malibu?

Ignition switching is also one method of resetting your device without disconnecting the battery. By turning both your ignitions on and off simultaneously after a second in each step, you can start your car. via

How do you unlock a 2002 Chevy Malibu radio? (video)

https://www.youtube.com/watch?v=SmWczBBeLJw

What does the symbol of a car with a lock mean on a 2010 Chevy Malibu dashboard?

The car and lock symbol is the Chevy Malibu immobilizer warning light. This light should come on briefly when the engine is started, then go out. If the immobilizer light stays on, it means there's a problem with arming or disarming the theft-deterrent system. via

Where is the fuse box on a 2005 Chevy Malibu? (video)

https://www.youtube.com/watch?v=BREFsUZyPAo

Where is the radio fuse in a 2004 Chevy Malibu?

Fuse box location

It is located on the passenger side of the vehicle, on the lower portion of the instrument panel near the floor, behind the cover. via

How do I disable GM PassLock? (video)

https://www.youtube.com/watch?v=y9QQrrRxrxI

How do I turn off pass key 3?

  • Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
  • Look at the dashboard and locate the theft system light.
  • Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.
  • via

    Leave a Reply

    Your email address will not be published.