Where is the thermostat located on a 2002 Oldsmobile Silhouette?

The thermostat's housing rests beside the engine head. The easiest way to locate it is to follow the upper radiator hose from the radiator to the point where the hose connects to the engine. The hose connects to the thermostat housing. via

Where is the coolant thermostat located? (video)

https://www.youtube.com/watch?v=AOSRVxA_RRQ

Where is the thermostat located on a 2002 Oldsmobile Alero?

Look on the middle of the engine block on the passenger's side and find the metal housing bolted to the water pump housing; this is the thermostat housing. Remove the two bolts, securing the thermostat housing. via

Is the thermostat and thermostat housing the same?

The thermostat housing and the thermostat itself are two different components and do not necessarily need to be replaced together or at the same time. The housing is just a piece that covers the thermostat that also has an opening for a radiator hose which is where the water enters and exits the motor. via

How do you test if the thermostat is working? (video)

https://www.youtube.com/watch?v=rrcwNOxQTbE

Is it bad to drive a car with a stuck open thermostat?

When a thermostat is stuck open, the coolant circulates constantly, and the engine takes longer to reach operating temperature when the thermostat is stuck open. In the long run, this will cause the engine to run out of power and cause years of damage to the engine. via

What is the difference between a thermostat and a temperature sensor?

Temperature Sensors provide an analogue output, the description of a device with a digital output is known as a Thermostat. via

How long does it take to replace thermostat in car?

It will take a mechanic between 1 to 2 hours to complete a thermostat replacement service. Depending on the shop you go to, labor can cost between $65 and $100 per hour, so call ahead to get a repair estimate. via

When installing the thermostat What is the correct position of thermostat?

The thermostat jiggle pin is a pin that is located in the small hole in the plate valve of the thermostat and which should always be in 12 o'clock position during installation. It helps bleed the cooling system of trapped air by allowing air to pass into the radiator, after which it can be released from the system. via

How do you test a bad thermostat?

To be sure, remove the thermostat from the engine and drop it into a bucket of boiling water (over 200 degrees). The thermostat should open while it's submerged close once it's pulled out. If it fails this test, the thermostat is defective and should be replaced immediately. via

Leave a Reply

Your email address will not be published.