brujasdeaskani

How do I clean the carburetor on a pressure washer? (video)

https://www.youtube.com/watch?v=Xq_oOL4vJYQ

How do you clean a clogged carburetor?

Dilute cleaner.

Clear air filter.

Remove the carburetor.

Remove carburetor float.

Remove other removable components.

Soak and scrub components.

Rinse and dry.

Reassemble and replace.

via

How do you clean a carburetor without removing the shell?

Spray liberally with carb cleaner – trying to direct the cleaner into the jets – and leave to soak for a few minutes. Use an air line (or a can of pressurised air, sold as an 'air duster') to blow through the jets. Repeat the previous step and this one until you can see no more gunge. via

What would cause a pressure washer not to start? (video)

https://www.youtube.com/watch?v=hVzp_YxOaUc

Why does my pressure washer start then shut off?

A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to run stall. via

How do you know if your carburetor is clogged?

It just won't start. If your engine turns over or cranks, but doesn't start, it could be due to a dirty carburetor.

It's running lean. An engine “runs lean” when the balance of fuel and air gets thrown off.

It's running rich.

It's flooded.

via

How do you unclog a jet carburetor? (video)

https://www.youtube.com/watch?v=fgwYC--ZLIc

Will seafoam clean carburetor?

Use Sea Foam Spray to safely and effectively clean residues and deposits from intake valves, chambers and compression rings! Sea Foam Spray delivers a high concentration of petroleum cleaning solvency and lubricity to carburetor throttle valves, intake runners and valves, and chamber areas. via