What Ford has a 8.8 rear end?

8.8 IRS (Independent Rear Suspension)

The 8.8 IRS first saw use in the 1989 model year Ford Thunderbird and later Ford adapted independent suspension to its 3rd generation Explorer and 2nd generation Expedition SUVs. The Mustang first used the 8.8 IRS on 1999-2004 Cobra models. via

What rear end does my Ford have? (video)

https://www.youtube.com/watch?v=90o5QtER-FI

What is the rear axle ratio on the new Ranger?

According to the manual and quick guide from Ford, all the Rangers still have a 3.73 axle ratio, including the Tremor. via

What did a Ford 8.8 come in?

First appearing in 1977, the 8.8 is found in almost all Ford V8 cars from '86 on, and in V6 Rangers and Explorers. There are 24 different Fords that offered the 8.8 rear axle. The weakest points of the 8.8 are the 28-spline axles (1.18 inches in diameter). via

What vehicles have Ford 9 inch rear end?

Common applications

  • 1957-1986 Ford F-100 & F-150.
  • 1958-1960 Edsel (All series including Wagons)
  • 1976-1980 Ford Granada.
  • 1976-1979 Lincoln Versallies.
  • 1957-1970 Ford Fairlane.
  • 1957-1971 Ford Thunderbird.
  • 1964 1/2-1973 Ford Mustang.
  • 1966-1983 Ford Bronco.
  • via

    What rear end do I have?

    Stamped Number on the Axle

    To figure out exactly what axle you have, you can look for the Dana stamped bill of materials number. This stamped number can usually be found on the righthand side or on the longer axletube on the same side of the tube as the differential cover, facing the rear of the truck. via

    How do I identify a Ford 8.8 axle?

    A Ford identifying tag is attached to one of the rear cover bolts. The four-letter code on the top right of the tag will be a dead giveaway as to whether you have found an 8.8-inch axle. The first three digits of these codes are listed with the original applications mentioned on the chart. via

    Why is the Ford 9 inch rear end so popular?

    The Ford 9-inch is desirable because it has a removable carrier, which allows quick rear end changes. Many racers carry an extra carrier assembly with a different rear end ratio so they can try different combinations on the same day while at the track. via

    How much HP can a Ford 9 inch handle?

    "They're good only to 400hp max," says Tom at Tom's Differentials. "Anything above that should use today's beefed-up, redesigned, nodular-iron aftermarket cases. They're good to 800 hp, if built properly. via

    Is limited slip the same as Positraction?

    A limited-slip differential (LSD) is a type of differential that allows its two output shafts to rotate at different speeds but limits the maximum difference between the two shafts. Limited-slip differentials are often known by the generic trademark Positraction, a brand name owned by General Motors. via

    Will the 2021 Ford Ranger have a manual transmission?

    The current six-speed automatic transmission available on Ranger will continue along with the introduction of a new five- and six-speed manual transmission for Single Turbo diesel variants. via

    Is the 2021 Ford Ranger EcoBoost?

    Performance and Fuel Economy. The Ford Ranger is available with just one engine option, a 2.3-liter EcoBoost turbo-four that makes 270 hp and 310 lb-ft of torque and is tuned for truck duty. Similarly, just one transmission is available: Ford's quick-shifting and well-programmed 10-speed automatic. via

    How much horsepower will a Ford 8.8 handle?

    Biggest problems I've heard with the 8.8's and high power is spun tubes and twisted axles. Dead stock (31 spline version, which is what the Explorer has) it can handle up to about 400 rwhp as long as you're not on DR's or Slicks. As soon as you go to those, you have to weld the tubes at a minimum. via

    How much horsepower will 31 spline axles handle?

    Bolt-on billet aluminum brake registers are machined to size based on your particular brake and wheel requirements. S/S 28- & 31-Spline Axles (28-spline up to 400 hp1, 31-spline up to 500 hp1) For street and handling performance applications, 31-spline S/S axles are recommended. via

    How do I know if my Ford has 9 inch posi? (video)

    https://www.youtube.com/watch?v=Y4gGLQ7hf1Y

    How do I identify a Ford 9 axle? (video)

    https://www.youtube.com/watch?v=KYX5t1tLNlU

    How do I identify my rear axle? (video)

    https://www.youtube.com/watch?v=tm2wMav0L0M

    What is the difference between 7.5 and 8.8 Ford rear end?

    The top and bottom of the 7.5-inch gasket are straight with rounded sides. The 8.8-inch gasket has flat sides, top and bottom, with rounded corners. via

    What vehicles have a Ford 7.5 rear end?

    All '79-85 Mustangs featured the 7.5 rear ends.

  • From '86-2010 the Ford Mustang 8.8 rear end went into all V8 Mustangs (5.0L, 4.6L & 5.4L)
  • The '99-01′ & '03-04′ Mustang SVT Cobras were equipped with an Independent Rear Suspension (IRS) that used the Ford 8.8” differential.
  • via

    Is a Ford 9-inch stronger than a 12-bolt?

    A Ford's 9-inch ring gear is larger than the 12-bolt's 8.875-inch ring gear. The Ford's larger ring gear plus its greater offset relative to the pinion results in a tooth contact area that's slightly deeper than a 12-bolt's, making the Ford marginally stronger. via

    Which is better Dana 60 or Ford 9-inch?

    The Ford 9-inch pinion is mounted lower in the carrier and has the greatest hypoid offset, which causes it to consume more power to drive it than the Dana 60 or GM 12-bolt. The Dana 60 has so much mass it too consumes a lot of power to drive (although many say it feels slightly less than a 9-inch Ford). via

    What rear end does Nascar use?

    NASCAR REAR END - FORD 9 inch Billet - Nitro Gear And Axle - NASCAR – www.RigidAxle.com. via

    How do I strengthen my differential? (video)

    https://www.youtube.com/watch?v=oQR5zZ7-K3g

    Is a 12 bolt rear end good?

    When the 12-bolt rearend is properly assembled, it's the strongest passenger-vehicle rearend Chevy ever produced. GM engineers designed the 12-bolt to be a durable piece that could handle the torque output of its big displacement engines. via

    How do I know if my truck has posi rear end? (video)

    https://www.youtube.com/watch?v=T0DeTzQWNBQ

    What is a Salisbury differential?

    The Salisbury diff is sometimes referred to as a 10-bolt because it has 10 bolts holding the crown wheel and there are 10 bolts holding the cover on. However, despite the similar name, there are absolutely no interchangeable parts between these and American GM 10-bolt diffs. via

    Can a Ford Ranger pull a 5th wheel?

    Because of their tough builds and high towing capacities, these trucks are capable of pulling a variety of trailers, fifth wheels, airstreams, and other campers. Ford Rangers can tow most types of campers, including pop-up trailers, travel trailers, teardrop trailers, airstreams, and small/medium fifth wheels. via

    Is Ford Ranger a good tow vehicle?

    As highlighted last month, the Ford Ranger XLT has all the fundamentals required to be an excellent towing vehicle. The fact that it comes standard with a 3500kg tow-bar and 12-pin plug is a good start, but there are other important attributes. via

    What type of rear suspension does the new Ranger use?

    What is the Rear Suspension of Ford Ranger?

    Variants 2020 Ford Ranger Raptor 2.0 Bi-Turbo 2018 Ford Ranger 2.2 XL (M)
    Rear Suspension Solid Axle Leaf Spring

    via

    What year did Ford Ranger stop making manual transmission?

    A four-speed manual transmission was standard on all engines for 1983 and 1984, with a five-speed manual as an option; a three-speed automatic was offered on 2.3L and 2.8L engines. via

    Leave a Reply

    Your email address will not be published.