Why do I not have power to my fuel pump?

In most of the cases, it is either a bad fuel pump relay or blown up fuel pump fuse which leads to fuel pump not getting power issue. But in some cases damaged fuel pump wiring, connections or a bad ground path in circuit are also common causes for no power to fuel pump. via

What gives power to the fuel pump?

The fuel pump relay sends a current to the electric fuel pump. A fuel pump relay is an electrical device much like an automotive fuse. It directs current to the electric fuel pump and ensures that the part receives enough power to operate properly, but not too much as to damage it. via

How do you wire an electric fuel pump to an ignition switch? (video)

https://www.youtube.com/watch?v=BGa6TG9LSFU

How do I test a relay without a multimeter?

How to test a relay without multimeter? Apply a 12 volt/9 volt/5-volt power supply to the coil (apply voltage according to the rating printed on it) and you will hear “crisp-click” sound, this indicates that your movable contact is working fine and thus the relay coil is in good condition. via

How many Ohms should fuel pump relay have?

Touch the test leads across the coil of the relay. You should read about 70 ohms. If the meter reads zero ohms, the coil is shorted and your relay is bad. If the meter reads infinite ohms, your coil is open and the relay is bad. via

Why would fuel pump relay go bad?

The most common cause of a fuel pump relay going bad is electrical power surges that increase the voltage. The fuel pump relay is designed to have a winding that causes contacts to pass current or voltage. What is this? In some cases, the current or voltage might be so high that the contacts get burned. via

How do you tell if a relay fuse is blown without a multimeter?

Put one wire to neutral/common, and one wire on the line side of the fuse. If voltage is present the bulb will light up. Now move the wire from the line side to the load side of the fuse. If the fuse is good the light will come on. via

How many volts should a fuel pump get?

System voltage should read 11.8 - 12.6v DC or higher with no electrical loads on the system. If voltage reads less, starting and charging system should be investigated before performing fuel system electrical testing. 1. Connect digital voltmeter to fuel pump wiring at fuel pump connector. via

Leave a Reply

Your email address will not be published.