How much oil does a Dodge Nitro 3.7 take?

Capacity: With filter 5 quartsAfter refill check oil level. via

How much oil does a 2009 Dodge Nitro 3.7 take?

The oil will need to be changed out every 7,500 miles but these vehicles come with an oil life indicator telling You when it's time. A 2009 dodge nitro will have a motor oil capacity of 4.7 Liters for models equipped with a v6 engine. via

What type of oil do I need for a 2007 Dodge Nitro?

Mobil 1 - Advanced Full Synthetic 5W-20 Motor Oil, 5 Quart (Part No. 14991) via

What oil does a Dodge Nitro take?

You can use 5W-20 oil in your parents' Dodge Nitro.

If you can't find 5W-20, you can substitute with semi-synthetic 10W-40. But the Nitro is built to operate at its best with the former. via

What oil does a 2008 Dodge Nitro take?

Mobil 1 Extended Performance Synthetic Motor Oil 5W-20 5 Quart. via

How much oil does a 2011 Dodge Nitro 3.7 l take?

Oil Capacity 4.0 L (6.0 qt.) with dry filter Coolant Capacity 13.5 L (14.3 qt.) via

What oil goes in 2011 Dodge Nitro?

Mobil 1 - Extended Performance High Mileage 5W-20 Full Synthetic Motor Oil, 5 Quart (Part No. 15020) via

What kind of oil does a 2011 Dodge Nitro use?

Castrol Edge Synthetic Motor Oil 5W-20 1 Quart. via

How do you reset the oil life on a 2011 Dodge Nitro?

  • Turn the key to ON/RUN position with engine off.
  • Fully depress and release the accelerator pedal 3 times within 10 seconds.
  • Turn the key to the OFF position and then back on to confirm reset was accepted.
  • via

    How many quarts does a 2008 Dodge Nitro take?

    Engine Oil

    With filter 5 quartsAfter refill check oil level. via

    How do you reset the TPMS on a 2007 Dodge Nitro?

    Ensure all tires are inflated to the pressure listed on the tire placard. When ignition is turned off, the system will be cleared and the TPMS telltale will turn off. The system will recalibrate when vehicle is operated at a speed of 30 mph for a minimum of 30 seconds. via

    How do you reset the tire pressure light on a 2011 Dodge Nitro?

    To reset this light all You have to do is fill the tire to the correct psiAnd drive the vehicle for 10-15 minutes at speeds of 15 mph or higher. The sensor will read the new pressure and turn off the light. via

    How do you clear the codes on a Dodge Nitro?

    You will need to turn on the Ignition Control button and off, as in the case of a vehicle's check engine light. With this method, the saved state of the computer is refreshed in a reboot attempt. The ignition will start firing after 1 to 2 seconds, and then turn off after 1-2 seconds. Three or four times in one step. via

    How do you check the oil on a Dodge Nitro?

  • Shut the engine off and set the handbrake.
  • Pull the dipstick out.
  • Wipe the dipstick out with a clean lint-free rag or paper towel.
  • Insert the dipstick back into the tube until it's fully seated.
  • Pull the dipstick out again and check the oil level.
  • via

    Where is the fuel filter located on a 2007 Dodge Nitro?

    The fuel filter is always going to be found between the fuel tank and the engine. For most vehicles, the fuel filter is located inside the top of the fuel tank, right where it connects with the fuel line, although on some cars if might be elsewhere along the fuel line. via

    How do you remove the oil filter on a 2009 Dodge Nitro? (video)

    https://www.youtube.com/watch?v=nvGOZWL-XOA

    Leave a Reply

    Your email address will not be published.