What does S RTRV mean on my Pioneer radio?

S.RTRV (sound retriever) Automatically enhances compressed audio and restores rich sound. 1 Press M.C. to select the desired setting. For details, refer to Enhancing compressed audio and restoring rich sound (sound retriever) on this page. via

What is advanced sound retriever? (video)

https://www.youtube.com/watch?v=rWoypImmRlA

How do you adjust a pioneer EQ? (video)

https://www.youtube.com/watch?v=tMLFL8K3gMM

What is SLA audio?

The SLA (Source Level Adjustment) function prevents radical leaps in volume level when. switching between sources. Settings are based on the FM volume level, which remains. unchanged. via

What should my car equalizer be set at?

At most, you want a 3-dB difference between each, with the 32hz frequencies on the higher end of a curve, a mostly-level 120 to 4,000hz, and a gentle dip down between 8,000 and 16,000hz. via

What is HPF setting?

A high-pass filter (hpf) is an audio frequency filter that cuts (filters out) frequencies below a set level. For example, if you set a high-pass filter at 300hz, you'd lose a lot of the bass sound from instruments that have frequencies in that lower range. via

What is reverse phase on subwoofer?

Setting the phase control to 180 degrees reverses the polarity of the subwoofer. In some application where the subwoofer is placed on a wall opposite from the speakers, reversing the subwoofer polarity can yield better in-room low frequency response. via

How do I adjust my Pioneer subwoofer? (video)

https://www.youtube.com/watch?v=umOTyFzqJDs

What is the best bass and treble settings?

The bass mid and treble should be set at a ratio of 4:5 as a rule of thumb. Don't overdo your bass adjustments, or your music will be distorted. via

What Hz is best for tweeters?

This can very well be the difference between a good sounding and a great sounding system. Recommended Starting Points: Tweeters - High-Pass Filter = 5,000 Hz (12 db or 24 db Slope) Midrange - Band-Pass Filter = 80 Hz HPF & 5,000 Hz LPF (12 db or 24 db Slope) via

How do I tune my HPF and LPF? (video)

https://www.youtube.com/watch?v=NduFCXmi6tc

What phase should I set my subwoofer?

Typically, though, phase is left at 0° for most applications. While seated in your listening sweet spot, play music with bass content that is familiar to you and then have someone switch the 0/180 phase switch on the sub to 180-degrees. This will let you determine if the bass sounds louder in your seating position. via

How do you get a sharp bass tone? (video)

https://www.youtube.com/watch?v=0KgB7wIyTUw

Should bass be compressed?

Compression will make the bass sound more even and consistent. By turning down louder notes in a performance, it will help each note play back at a more equal level. This will add solidity to the bass and help it sit better in the mix. via

How do you make your vocals sound professional?

  • Top-End Boost.
  • Use a De'Esser.
  • Remove Resonances.
  • Control the Dynamics with Automation.
  • Catch the Peaks with a Limiter.
  • Use Multiband Compression.
  • Enhance the Highs with Saturation.
  • Use Delays Instead of Reverb.
  • via

    How do you remove sibilance from vocals?

  • Choose a microphone with a darker character.
  • Distance yourself from the microphone.
  • Tilt the microphone slightly off-axis.
  • Place your finger or a pencil against your lips.
  • Fix with a de-esser.
  • Fix with equalization.
  • Ride/automate the fader/levels.
  • via

    Leave a Reply

    Your email address will not be published.