Are Upgraded fuel injectors worth it?
Changing fuel injectors is not a “plug-and-play” performance upgrade, such as installing a low restriction air filter. It's something that requires knowledge about how the fuel delivery system works. In fact, upgrading fuel injectors may actually decrease the engine power if done incorrectly. via
Is it OK to buy remanufactured fuel injectors?
Since remanufactured fuel injectors have been rigorously tested and have had their internal parts replaced as needed, you get the reliability of a new injector. Plus, you get it at a lower price point. Remanufactured products are gaining ground because of these advantages. via
Can you have too big fuel injectors?
It's easy to fall into the trap of thinking that bigger fuel injectors equal more power, but unless your engine is set up to deal with the extra fuel, you'll be on a fast track to trouble. The excess fuel will flood the engine and it either won't run at all, or will be running too rich. via
Where are Bosch injectors manufactured?
Despite the fact that we do use genuine Bosch parts, many of Bosch's parts are manufactured in China. This isn't a secret. via
How long do remanufactured injectors last?
In general, they're expected to last a pretty long time. Both Bosch and Delphi, two major manufacturers of automotive components, say their fuel injectors have a life expectancy of 1 billion cycles. Essentially, that means that the fuel injectors should last as long as the car does. via
How much does it cost to recondition a fuel injector?
How Much Is It to Replace Fuel Injectors? On average, you can expect to pay between $350 and $850 to replace your fuel injectors. via
Are Dieselogic injectors good?
Dieselogic - no good.
Way worse - took it in for a diag - 5 of the 8 injectors balance rates are all over the place. Fuel knock is bad under load - only goes away if rail pressure is tuned below 4k. via
What do higher cc injectors do?
The larger the diameter, the more fuel an injector can deliver. As fuel injector size increases, there are some unwanted side effects. As an injector's hole gets bigger, the minimum amount of fuel it can flow also gets larger. via
What is loop injector?
In HPLC, whether the injection is manual or automatic, the injection is performed with an injection loop that must be filled and then injected into the system. The volume of the injection loop plays a major role in the volume of sample injected. On a general basis, injection loops vary from 1 to 100 µL. via
What are the advantages of HPLC?
Advantages of HPLC over Thin-layer Chromatography (TLC)
Should you replace all fuel injectors?
Some fuel injectors are rated to last one billion cycles or approximately the lifetime of the vehicle. But when you factor in the adverse conditions experienced in real-world driving coupled with a lack of proper maintenance, most fuel injectors might need to be replaced every 50,000 to 100,000 miles. via
Can injectors be reconditioned?
Remanufactured Injectors
Injectors that undergo the remanufacturing process may be slightly more expensive than those that are refurbished but the cost is often worth it. Remanufactured or rebuilt injectors are completely disassembled and each component is thoroughly inspected for defects. via
Who made fuel injectors?
The concept of direct fuel injection has been around since 1925 when Swedish engineer Jonas Hesselman invented it. During WWII, some fighter planes were equipped with direct fuel injection to prevent stalling during high speed aerial maneuvers. via
How do you upgrade injectors? (video)
https://www.youtube.com/watch?v=zybmfDslKp0